It will slow you down since you'll need to keep moving it though. You could also try using a wide sheet of cardboard, plywood, or something to put up against your fence. They're not as powerful as gas ones and have thinner line. It not only solves that one issue but it adds beauty, increases your property value and adds a little bit of isolation between you and your neighbors depending on what you plant.Īnother option is to pick up a cordless string trimmer. The best thing to do would be to just create a mulched flower bed around the perimeter of your yard by the fence so you don't need to use your string trimmer up against the fence. It's a one-time cost for the Sawzall, a couple hours of time to mark and cut the boards and then you are done. Personally, I'd opt to cut 1.5 inches off the bottom of the fence and be done with it. The problem with this solution is that (I'm assuming) if you share the fence with a neighbor, you've both got to be on-board with the solution or the weeds and grass are going to crop up on the other side anyway. They make that edging in plastic and in metal too. You could skip the edging but you'd probably end up with a fair amount of grass clippings in the mulch or shooting mulch all over the yard with the trimmer. Some of that push-in edging would give you a clean line to separate out the mulch from the grass. Put down some pro-grade weed fabric and and put several inches of mulch atop that to smother the weeds. You could decide to run a strip of mulch along the fence line. These solutions - Round-up or vinegar - will result in a brown area along the fence line which might be undesirable. Vinegar is moderately effective at killing weeds and is cheap (at least the 5% stuff is). ![]() A more eco-friendly possibility might be vinegar (20% is available and is quite effective but requires some special handling (gloves, goggles) due to its caustic nature). That will definitely kill the grass and could be applied periodically. That's likely one of the easier "one time" solutions to the problem.Īnother possibility (though I try to avoid its use on our farm) is some sort of non-selected spray such as Round-up. You could cut them so there is 1.5 inches or so of clearance on the bottoms and probably keep the wood from being chewed up by the string trimmer in the future. A reciprocating saw (Sawzall is what they are called typically) would make quick work of this. It's a pain to cut pickets near the ground that are installed. ![]() You could cut a little off the bottom as ekaj suggested in the comment above. You've got that nice fence there so you don't want to go junk it up with some junk laid under it. That will work but cardboard breaks down and none of these are all that appealing. under the fence to essentially create a weed block. I've seen folks slide old shingles, cardboard, carpet, etc. That might help but there are a lot of variables here - the ground height, the movement of your arms, the amount of grass and where it is located, etc. You can certainly try to do it more slowly and angle the string down toward the ground. Trimming along a wooden (or chain link!) fence is tough and tears up the wood undoubtedly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |